Utilizing a pair of channels, the Netgear AX1800 extender (model EAX15) is a WiFi mesh extender. By installing this powerful WiFi 6 mesh extender in your home, you can improve WiFi speed and coverage over the entire area. This page contains all the information you require about the Netgear EAX15 setup WiFi mesh extender.
Netgear EAX15 Setup manually
- Once the Netgear EAX15 is powered on, keep an eye out for the solid Power LED to illuminate.
- Using the device’s Wifi and password, connect it to the built-in WiFi of the EAX15.
- Open a web browser.
- Choose the existing Wi-Fi network, enter the password, and, if required, establish a new extended network.
- After putting the EAX15 where it is needed, check to see if the connection is stable by looking for a solid LED. Everything is ready to go!
Note: If you need any assistance regarding your netgear eax20 wifi extender so get in touch with our technician or visit the official website that is mywifiext.net setup.
Configure the Netgear EAX15 using the WPS method
- You should plug the Netgear EAX15 into a power outlet near your existing WiFi router.
- Locate and press the WPS button on the Netgear EAX15. This activates the WPS feature of the extension.
- Within two minutes, go to your WiFi router and press the WPS button. By doing this, the EAX15 and your existing Wi-Fi network are connected.
- The Netgear EAX15 may need some time to establish a connection with your router. The WPS LED on the extension should indicate that the connection was successful.
- After the connection has been established—a steady LED on the EAX15 will indicate this—move the extender to the desired location in your home or place of business where you want to increase the Wi-Fi coverage.
How can I log in on my NeGEAR EAX15 setup?
Link up with the EAX15:
- Make sure your EAX15 is powered on and correctly linked to your network.
Locate the IP address:
- On a device that is linked to the same network as your EAX15, launch a web browser.
- In the address bar, type the EAX15’s default IP address. To find the correct IP address, use the NETGEAR Genie app or consult the equipment handbook.
Login Page:
- You need to be taken to the login page after inputting the IP address. Enter the default password and username if prompted. Usually, the default credentials are:
- Login as admin
- Enter a password, or leave it empty.
Password Change:
- To secure your device, changing the default password is strongly advised. Check the online for the password settings.
UPDATES FOR Netgear EAX15 FIRMWARE?
- Open the web connection on your extender and log in. Open a web browser, enter your login information, and enter the extender’s IP address to do this.
- Go to the NETGEAR support page and find the model of extender you own.
- Download your extender’s most recent firmware upgrade.
- Check the web interface of the extension for a “Administration” or “Firmware Update” section.
- Select the upload option once the firmware file has been downloaded.
- By following the directions displayed on the screen, you can initiate the firmware upgrading procedure.
- A reboot may occur while the extender is being updated.
- Let the update finish. This could take a few minutes to complete.
- See if there have been any updates:
- Following the update’s
How do I reset the my Linksys EAX15?
The Linksys EAX15 extender can be reset by doing the following:
- Usually, the reset button is on the side or bottom of the extension.
- Press and hold the reset button with a paperclip or other tiny tool for around ten seconds.
- Press the reset button as soon as the power LED begins to blink.
- Allow the extender to complete the reset process over time.
- Turn off the extension, wait 10 seconds, and then turn it back on.