EcoGujju

EcoWorld help to Own

Residential Roofing Repair: Fixing Common Counter Flashing Problems

3 min read
residential roofing repair

Lots of residential roofing repair involves fixing common counter flashing problems. There are various approaches to keep our homes dry as well as our chimneys. One of those ways is by having a counter flashing on the chimney. What is counter flashing? Counter flashing is made of galvanized steel. It channels water away from the roof sections of the wall. Roofers install flashing around vents, skylights, and chimneys. 

There are several reasons why homeowners should consider counter flashing as a necessity. Also, they should note problems with counter flashing and the types of materials used for making it. Installation of counter flashing, issues, maintenance, and when to contact a professional roofing contractor to check it should be noted.

Why You Need to Know About Counter Flashing 

All things considered, if your home has any brick on it, you need to ensure that counter flashing is utilized in the construction. Counter flashing is frequently used to flash chimneys. It is made with the purpose to redirect the water from the chimney and down the siding. 

What is Counter Flashing 

Counter flashings are used on chimneys or where a divider joins with a roofline. There are two layers of counter flashing: The first is the base and is at the bottom of the chimney, and the second one is embedded into the brickwork of the chimney. The purpose of counter flashing is to sit on top of the base flashing to ensure water doesn’t go past it. Instead, streams water down the roof or through the gutter. 

Problems with Counter Flashing 

You can see that counter flashing is vital to the chimney and the roof. In any case, homeowners need to depend on the worker to install it when laying the brick and mortar. This will make it work best. Unfortunately for certain workers, this is an excess of work. So they skip this sequence then, at that point, the roofer has to remove an edge and seal it later on. The terrible thing about this is the sealant in the long run wears out, and leaks into the home can occur. 

Another issue is a few groups install it erroneously. The counter flashing should be installed higher on the divider. 

When to Call a Professional 

If you notice water coming into the home or issues on the roof or close to the chimney, call a professional for help. They can assist with a permanent solution. Also, give a valuable response to any questions you may have. Don’t fall for roofers that are not experienced. They would only make things worse.

Conclusion 

Counter flashing is indispensable any place you have brick on a home. This is normally on the roof and chimney areas. Occasionally it should be installed because it dissipates rapidly and calls for replacement. As a general rule, the logic is to consistently keep water outside of the home. Always invite professionals to inspect your chimney. Only then can you enjoy your home without fear of leaks. 

Leave a Reply

Your email address will not be published. Required fields are marked *